Augusta Water Heater Maintenance in 10 Minutes

Posted by on Feb 25, 2014 in Water Heater Repair Augusta GA

We are going to put you to work today, but only for about 10 minutes. Yep, that’s all it will take for these two important water heater maintenance tasks; nonetheless, Water Heater Repair Augusta GA¬†understands they will do an outstanding job of assisting with 3 things:
Having your water heater last as long as possible (that will save you money).
Ensuring the water heater runs safely (we do not want it to blow up).
Having it run as energy efficiently as possible (also conserving you cash).

So with that in mind, are you prepared to invest 10 minutes once or two times a year to assist in saving some cash? Water Heater Repair Augusta GA thought so.

Testing the T&P Relief Valve

Typically called the T&P Valve, or the temperature and pressure relief valve, has a vital job. It assists ensure excess pressure does not build up inside the water storage tank, or in even more simple terms, it makes sure the water heater does not explode. As the photo shows, it has a lever or little deal with on it. All you need to do is lift it part means and afterwards release it. Hopefully, it snapped back to its closed position quickly. If it is working properly, a little water can be heard entering into the drain pipe below the lever you just raised and you maybe heard some pressure being released. If none of these things have actually happened throughout the test, the valve will need to be replaced.

Perform a Mimi Water Heater Tank Flush

By nature, rust and rust will occur inside the water tank thanks to the chemical reactions taking place with all the elements inside that are needed to warm the water. We will not get too technical right here, however it is easy to assist prevent this from happening by doing a flush or draining of all or some of the water in the storage tank.

For simply a tiny flush, place a pail under the drain valve below the tank. Open the drain valve and fill the container with water. Drain at least a couple of gallons of water in all. Let the water sit in the pail for a couple of minutes to settle and examine if there is much that settles to the bottom of the bucket. If there is, if the water heater has not been drained for a long time (or ever), it would be best to do a complete flush of the tank to get as much of the sediment out as possible. You will desire to turn the temperature dial down and might desire to let the water cool off for about an hour first so it is not too hot while draining it. Likewise, it would be easier to attach a hose to the drain valve and let the water go outside instead of making use of buckets.

If the water looks relatively clean and clear from the small test you should be all set. When the water heater has an excessive amount of sediment inside of it, it can make loud popping noises and it lowers its effectiveness too.

Though water heaters are relatively maintenance free and simple to operate, at any time you feel the tiniest uneasy or are not sure of exactly what to do, it is always best to have a plumbing professional aid with the circumstance.

Water Heater Repair Augusta GA