Augusta Water Heater Venting Options

Posted by on May 13, 2014 in Water Heater Repair Augusta GA

The following concepts about appropriate water heater venting from Water Heater Repair Augusta GA below are shared in order for house owners to have a basic understanding of how the different kinds of venting work. They are not meant to be how-to directions for homeowners to perform themselves. The training and licensing of a professional plumbing repair service specialist is exceptionally important.

In terms of venting, water heaters are usually vented in two methods; direct vent water heaters and power vent water heaters. So what is the leading distinction between the two types of water heaters? A direct vent water heater vents the combustion gases created from the water heater’s burner directly to the atmosphere, while a power vent water heater removes them with the aid of a powered ventilation fan.

This video gives some tasks to perform to help see if your water heater is currently properly vented:

Direct Vent Augusta Water Heaters

In a direct vent water heater, the heat produced from the combustion procedure is made use of to heat the water. The exhaust gases are then transferred to the exterior of the house via the exhaust pipe or chimney.

As far as direct venting, it works with the theory that heated air is lighter than cool air and will then rise naturally due to the difference in buoyancy in between the cold and hot air. This is a delightfully basic system that works well when the exhaust gases can be vented vertically. No extra power is needed, and in turn the general hot water heating expenses are lower.

The following video explains in more detail the details of a direct vent system:

Power Vent Augusta Water Heaters

Power vent water heaters uses a fan or blower to help in the discharge of exhaust gases from the hot water heater. For places that don’t have access to a vertical vent or chimney, power vent water heater could be the only selection. With the use of a fan or blower, exhaust gases can be pressed through horizontal exhaust vent pipes.

The main advantage of a power vent water heater then is the capability to find the water heater far from a chimney. Or if there is no chimney offered, to conserve money by horizontally venting it to the outside through economical venting pipe instead.

The disadvantages of a power vent system vs. a direct vent heater are that power vent heaters will cost more money to at first because of the extra equipment (fan/blower) required for the install. Also, one will also have to run a power line to the fan. This too, will contribute to the cost.

An additional disadvantage is that the blower section of the water heater will need electricity to operate. This will increase the hot water heating expenses throughout it’s lifetime, though not that much.

And finally, the fan noise can be heard operating when the hot water heater is running. While it’s most likely only a minor concern, it’s something that should be seriously considered. Correct setup can assist to get rid of, or at least minimize many of this.

Though there are some differences between the two types, it really depends on a homeowners specific situation, in regards to the installation location, and the ability to create a vent path to the outside of the home.  Augusta Water Heater Repair recommends taking a look at the ENERGY STAR info right here too in terms of the various energy efficiency ratings for the different types of sorts of heaters.

Enhanced by Zemanta